- Active Posts:
- 9 (0 per day)
- Most Active In:
- Mechanical Markers (5 posts)
- 11-September 07
- Profile Views:
- Last Active:
- Oct 06 2009 01:45 PM
- Member Title:
- Forum Newbie
- Age Unknown
- Birthday Unknown
- Not Telling
Posts I've Made
20 May 2008 - 01:27 AMI have the same problem: little CO2 (or Air) leak from the grip of my SP1 when I shot...and the fps is ok = 280...
I dont know if this is a problem or not...I think it is not normal...I will check microline tomorrow...
but check that anybody please...if that leak is in every SP1 or Vibe (the internals is the same in both markers) than it is not a problem i think...just disassemble the grip and shot several times and watch if the CO2/Air is not leak from place where the battery is connected to board...
15 May 2008 - 01:19 AMwhat about this: http://www.specialopspaintball.com/shop/pr...p;CAT=107208302
it is compatible with SP1...?...
to MadChild: good thread...
25 April 2008 - 12:18 AM#6
16 April 2008 - 01:37 PMgood idea!...
28 November 2007 - 04:51 AMCheck out this post about putting feed tubes on top of Spyders. There are some pretty sweet ones on the second page. Hope this helps.
thanks...that spyder Xtra on second page is my...
...but that tube loader works differently than longbow loader...i think better...
here is that Link again...where u can find additional info...
deadhy hasn't added any friends yet.