Special Ops Paintball: Timmy bounce is to much - Special Ops Paintball

Page 1 of 1

You cannot start a new topic
You cannot reply to this topic

Timmy bounce is to much how do u turn it down?

#1 BrutishOpus

Junior Member

Group: Members
Posts: 855
Joined: 05-September 05
Location:Washington

Posted 15 January 2007 - 04:48 PM

I have a Ripper and it has a frenzy board in it, its a great marker when I dont rip with it but right when I start to rip it, it chops, I have had this marker for about 2 years and have used tons of diffrent brands of paint and have used diffrent barrels and theres no burrs in the breech or anything so I just shot kind of slow with the marker since I've had it and I wondered if the settings are the cause of the chopping, and it bounces like crazy, I have a Reloader B so the hopper isn't the problem any suggestions for board settings?

#2 heisman01

"the appraiser"

Group: Members
Posts: 1,652
Joined: 19-November 05
Gender:Male
Location:lawrenceburg IN
Brigade Name:heisman01

Posted 15 January 2007 - 05:09 PM

eyes might have gone bad... there should be a debounce setting and probly an eye delay or just return the board to stock settings if uve altered them

new PBN feedback old PBN feedback SO feedback ebay feedback IOG feedback
[size=4]I BALL FOR A CURE

#3 DanteDevil

Most Hated

Group: Members
Posts: 360
Joined: 22-November 05
Brigade Name:DanteDevil

Posted 15 January 2007 - 07:09 PM

go to timmy site find out how to reset board factory defaults or check PBN timmy section

#4 Finnish Sniper

Virtue is the engine inside!

Group: Members
Posts: 158
Joined: 23-November 05
Location:Mishawaka, IN
Brigade Name:finnish sniper

Posted 17 January 2007 - 12:48 PM

and then put a new battery in and make sure all the wires are completly pushed together.

ETek FST !$%~The Pimptastic Baller's Myspace~%$!
SpecialOps Feedback: ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?
PBNation Feedback:? ? ? ? ? ?

Donate To Twisted Chaos' Field

#5 Ninja Jones

Canadian Intergalactic Space Ninja Pimp

Group: Members
Posts: 1,770
Joined: 15-May 05
Location:Calgary, AB, Canada
Brigade Name:Ninja Jones

Posted 17 January 2007 - 09:13 PM

Try a higher Ball Detection Time Value (+1 or 2 from your current setting)
Turn the Debounce/Anti-Bounce up

Check to see if your eyes are working properly...