Special Ops Paintball: Timmy bounce is to much - Special Ops Paintball

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Timmy bounce is to much how do u turn it down?

#1 User is offline   BrutishOpus 

  • Junior Member
  • PipPipPipPip
  • Group: Members
  • Posts: 855
  • Joined: 05-September 05
  • Location:Washington

Posted 15 January 2007 - 04:48 PM

I have a Ripper and it has a frenzy board in it, its a great marker when I dont rip with it but right when I start to rip it, it chops, I have had this marker for about 2 years and have used tons of diffrent brands of paint and have used diffrent barrels and theres no burrs in the breech or anything so I just shot kind of slow with the marker since I've had it and I wondered if the settings are the cause of the chopping, and it bounces like crazy, I have a Reloader B so the hopper isn't the problem any suggestions for board settings?

#2 User is offline   heisman01 

  • "the appraiser"
  • PipPipPipPipPip
  • Group: Members
  • Posts: 1,652
  • Joined: 19-November 05
  • Gender:Male
  • Location:lawrenceburg IN
  • Brigade Name:heisman01

Posted 15 January 2007 - 05:09 PM

eyes might have gone bad... there should be a debounce setting and probly an eye delay or just return the board to stock settings if uve altered them

#3 User is offline   DanteDevil 

  • Most Hated
  • PipPipPip
  • Group: Members
  • Posts: 360
  • Joined: 22-November 05
  • Brigade Name:DanteDevil

Posted 15 January 2007 - 07:09 PM

go to timmy site find out how to reset board factory defaults or check PBN timmy section

#4 User is offline   Finnish Sniper 

  • Virtue is the engine inside!
  • PipPip
  • Group: Members
  • Posts: 158
  • Joined: 23-November 05
  • Location:Mishawaka, IN
  • Brigade Name:finnish sniper

Posted 17 January 2007 - 12:48 PM

and then put a new battery in and make sure all the wires are completly pushed together.

#5 User is offline   Ninja Jones 

  • Canadian Intergalactic Space Ninja Pimp
  • PipPipPipPipPip
  • Group: Members
  • Posts: 1,770
  • Joined: 15-May 05
  • Location:Calgary, AB, Canada
  • Brigade Name:Ninja Jones

Posted 17 January 2007 - 09:13 PM

Try a higher Ball Detection Time Value (+1 or 2 from your current setting)
Turn the Debounce/Anti-Bounce up

Check to see if your eyes are working properly...

Share this topic:

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users