Special Ops Paintball: FS/FT -Custom PGP and parts- FS/ FT! - Special Ops Paintball

Jump to content


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

FS/FT -Custom PGP and parts- FS/ FT! Rate Topic: -----

#1 User is offline   paintman161 

  • Forum Member
  • PipPip
  • Group: Members
  • Posts: 61
  • Joined: 20-March 08
  • Gender:Male
  • Location:Rochester, NY
  • Brigade Name:paintman161

Posted 24 February 2011 - 04:28 PM

I have a pre 2k PGP with cartridge valve! Has a new 12g face seal and new pierce pin from PPS. The saftey works and has the spring and ball bearing replaced. New hammer spring and rear velocity screw. The stock bolt has both ball bearings and spring to lock it in place. Plus some misc parts in bag.

NOTE: There is a small leak coming from the valve that leaks out of the barrel!

PGP stock as shown come with stock pump handle and the wood one
$70 shipped
Posted Image
Posted Image
bag of parts comes with PGP! Feed plug is gone!
Posted Image

Red delrin Bolt-(additional holes taped for mode below still works as stock
$22 shipped
Posted Image


BUY everything for $85 shipped!!


Trade: None cash is king!

This post has been edited by paintman161: 27 February 2011 - 08:09 AM

MCB feedback
PBnation feedback
Spec ops feedback

My review of the Tacamo MK7P kit!
Tacamo MK7P review
0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users