[365]

Quick question has anyone installed a T2W stock on an NXT shocker? I just bought one but Im kinda stumped how to install it, The ASA is is screwed from the handle down not your normal ASA up. Does that make since? Any one have pictures of the stock connected to the shocker?

Thanks for the help

[blackcelldrumr15]

If that is the case, get some longer bolts and nuts and bolt it to the frame! Problem solved!

[Tenacious221]

Sound's like you're trying to use some kind of dovetail setup there.

My suggestion is pulling out the screws in the grip you're trying to use, then install from the bottom using the screws that should have come with the T2W stock.

-Tenacious

[blackcelldrumr15]

Ahh good call Ten, didn't think of that.

[365]

blackcelldrumr15, on Jun 29 2010, 09:08 AM, said:

If that is the case, get some longer bolts and nuts and bolt it to the frame! Problem solved!

if i just bolt it to the bottom of the grip then it wont look as clean and ill have 2 nuts sticking out the bottom of the grip (not a big fan but it'll work)

Tenacious221, on Jun 29 2010, 09:10 AM, said:

Sound's like you're trying to use some kind of dovetail setup there.

My suggestion is pulling out the screws in the grip you're trying to use, then install from the bottom using the screws that should have come with the T2W stock.

-Tenacious

Also Tenacious thanks, thats what i was planning on doing but, i bought it used and it did not come with the screws.

blackcelldrumr15, on Jun 29 2010, 09:18 AM, said:

Ahh good call Ten, didn't think of that.

Also im not 100% sure but i think the screws holding the ASA on are smaller than the ones used on the stock. if thats the case then ill have to drill out the bottom of the grip frame then bolt it that way. id still like to have pics if anyone has them.

[Tenacious221]

Call up Brady at special ops and he can probably send some screws out to you.

call 1-866-396-6006

-Tenacious