Posted 14 October 2009 - 12:59 PM
I also noticed my autococker's IVG has four different velocity settings thats it. It is held in by the beavertail screw and there are four different holes that are different distances. I have mine so it compresses the spring the most and the velocity stays the same, so I am going to sweetspot my reg but I will probably have to get new springs because I am only shooting around 200. Which sucks cause it bounces ALOT and its REALLY easy to dodge it.
Posted 14 October 2009 - 01:27 PM
Posted 14 October 2009 - 05:58 PM
To sweetspot your reg leave the IVG in the middle, a few turns in, then ssweetspot the reg. After the reg is sweet spotted, then you can use the IVG to control your FPS. At that point ONLY use the IVG to control velocity. Leave the reg alone once it is sweet spotted.
I don';t know what you mean by 4 screw holes....there are four on the bottom of the body, but they are for mounting and holding, the first is for the front frame screw, second is for the valve set screw, next is for the rear frame screw, then the last is for the beavertail.
If you turn in the IVG too far you can have issues. Invest in a spring kit if you need to. But foir now sweetspot first, then see if the IVG can get you into proper range of velocity
Posted 14 October 2009 - 06:13 PM
Posted 14 October 2009 - 06:21 PM
Posted 15 October 2009 - 02:25 PM
Are there large threads cut into the bottom tube for your IVG? If so, you can grab any old one. If not, you need to get a Belsales Rex Dialer (compulsivepaintball.com) to adjust the velocity via your spring compression. Any idea what valve you have in there? What inline reg do you have?
This post has been edited by flyweightnate: 15 October 2009 - 02:26 PM