Special Ops Paintball: Cocker Microline Removal - Special Ops Paintball

Page 1 of 1

You cannot start a new topic
You cannot reply to this topic

Cocker Microline Removal Rate Topic:

#1 anti_arrows

Would You Kindly?

Group: Members
Posts: 439
Joined: 20-October 06
Gender:Male

Posted 16 June 2009 - 05:43 PM

I just need a quick answer. Whats the best way to remove microline on the front of a cocker? I tried last time and i riped the hose up, any techniques or such?

Offical Pump Club Member #159
You Can't Wipe A Welt
Yeah My Gun Has PSP...Pump Shoot Pump

#2 flyweightnate

Closed bolt. Rock n cock, or rock n roll.

Group: Members
Posts: 1,595
Joined: 17-June 07
Gender:Male
Location:NY or GA Tech
Brigade Name:flyweightnate

Posted 16 June 2009 - 07:07 PM

Side cutting pliers, a razor blade, and some replacement hose.

Feedback.
"Listen to nate hes always right, no joke"- Mighty Mike

#3 Side-Swipe

Born in the USSR, I have no country to call my own

Group: Members
Posts: 393
Joined: 05-February 07
Gender:Male
Location:Chicago, Illinois
Brigade Name:Side-Swipe

Posted 18 June 2009 - 12:19 PM

I use small pliers grab right at the end of the nipple and pull

My Feedback

#4 Viherkogen

God's In His Heaven. All's Right With The World.

Group: Members
Posts: 950
Joined: 22-July 05
Gender:Male
Location:Columbus, GA
Brigade Name:Viherkogen

Posted 18 June 2009 - 12:42 PM

It's been a while for me, but I used to get a small fine tipped flat head screwdriver (or anything thin and flat) and pry the hose end off the barb. Failing that, I would use needle nose pliers, grab as close to the barb as I could, and twist while pulling at a 45* angle.

|| My Feedback || 187 BP ||
|| Reasons one and two why my avatar is a cactus. ||
|| The early bird may get the worm, but the second mouse gets the cheese. ||
|| If actions are stronger than words, why is the pen mightier than the sword? ||
You just lost The Game.

#5 Sneaky Sir

Studyin' my pump-fu

Group: Members
Posts: 971
Joined: 23-June 06
Gender:Male
Location:Gibbon, MN
Brigade Name:Sneaky Sir

Posted 18 June 2009 - 04:08 PM

Find a non-tooth pliers or one with very small teeth, and then grab below the barb, don't actually grab the barb or you could rip it, and then just pull.