Miltec G2 Quickcap Installation problem
Posted 04 April 2009 - 07:05 PM
The problem I'm having is; the quick cap has a threaded screw attached to its right side that seems to line up with the hole on the right side of the clip. The only problem is, the hole is slightly too small, is not threaded, and has a small metal rod inside that is used for connecting the clip to the marker. I wish I could take a picture and post it, but I do not have a digital camera available at the moment.
Does anyone know of a fix to this? or am I just installing it incorrectly?
Posted 02 July 2009 - 02:02 PM
Simply put, I was sent the wrong one.
My G1's ballfeed had a female threaded hole & the 1st speed cap sent had a tiny non threaded pin.
I had to call the retailers distributor (as per there PITA request) and spend 15 minutes on the phone before they understood the problem.
Was it Jasse?
This post has been edited by foster: 02 July 2009 - 02:03 PM
My hand decided that the time was nigh
And for a moment it slipped from view
When it returned, it fairly burned with
Confidence anew… -N.C.