[TRU3]

Alright, so i just recently recieved (happily might i add) my forge vest and Zeus G2 from Specops. I was fooling around, wasted about half of the 12grams that i ordered with it shooting at a steel tub. Then, it seems slowly, that i started to get less shots (started out at about 13, put 3 12g into it, got up to 20, but then went down to 10 and would bleed air after the last shot).

Also, it is like 20 degrees out, so that may be wreaking havoc on the Co2 and it just cant build up the pressure as fast as it should, but i noticed when it acted as if the 12g was "empty", i would take it and it felt as if there was something inside. Upon shaking it upside down, it appeared to be snowing out of my 12 grams. If i plug the end of one that is like this, pressure builds beneath my thumb until i move it off and and escaping cloud of gas comes out. Is this completely frozen Co2? Is it just so cold right now that it would be best to wait until it got warmer to test?

And onto the main topic. Were i to upgrade the internals, would THIS and THIS (The one above Zeus g1 and g2 cup seals) help with efficiency and possible leaking problems?

[-SMITTY-]

cold+co2 dont mix. it's best for 50* and up. you don't really need a new cup seal and bolt

[Maj Tom]

That ^^

And the "snow" is actually dry ice.