[Bobbjoe]

My pmr which is about 4 weeks old has just started leaking out of an area around the trigger. The leak is hardly noticeable, and the gun still works fine, but I'm kind of worried about it. I have only made slight velocity adjustments, so I'm sure that I have not blown the solenoid by over pressurizing it. Anyone have any idea whats going on?


Also, I've tried replacing many of the O rings in the bolt.

[Phantom9399]

when you take the bolt out, there is an o-ring that's almost on the bottom... its on the vent that the air comes into the bolt, did you replace that one?

if you go to actionvillage there is a complete o-ring kit for the PMR for only 7 or 8 dollars... i would just replace every o-ring cause the kit is so cheap

here is a link...

http://www.actionvil...om/011-269-0146

[Bobbjoe]

Phantom9399, on Dec 23 2008, 02:49 PM, said:

when you take the bolt out, there is an o-ring that's almost on the bottom... its on the vent that the air comes into the bolt, did you replace that one?

if you go to actionvillage there is a complete o-ring kit for the PMR for only 7 or 8 dollars... i would just replace every o-ring cause the kit is so cheap

here is a link...

http://www.actionvil...om/011-269-0146

Yeah, i did replace that one.

So i just took the solenoid out to relube its seat. The leak got bigger when i screwed it back in, so i think its the rubber seal that it sits on that's the problem.

[Phantom9399]

it might be the rubber seal

just make sure your eye wire isnt pinched anywhere and its where it should be

other than that, i dunno how to help

[Bobbjoe]

I sent it into proto.. three weeks ago.. Does anyone know the normal turn around time for repair?