Blazer 1k What's people's opinions?
Posted 02 November 2008 - 03:06 PM
Posted 02 November 2008 - 03:20 PM
That's a good read. Should answer you're questions.
I love my Blazer. Infact I'm saving to send it home to PPS fro something special. I'm also hoarding parts away for a future E-Blazer build.
If I had the choice between the 1k and 2k I'd go 2k. Slight more refined & the bolt can't shoot out the back of the gun. Just 2 quickioes I can think of. There's alot of info in the link above.
Posted 02 November 2008 - 03:37 PM
I'm more wondering what the idiosyncracies of the 1k vs the 2k are... I know enough about the 2ks, but don't know the evolution so well.
Posted 11 November 2008 - 08:33 PM
Yikes! This thing is amazing! and
Sheesh, did they superglue these switch cups in here?
lol I was just reading "your" thread on MCB about it.
Posted 12 November 2008 - 03:55 PM
I called Lori and she said they'd use an ultrasound to remove 'em if I sent it in. $25 for labor, though... minimum, depending on how long it took.
I'm gonna try and find an ultrasound vibrator on campus to shake the seals clean with, if it starts leaking heavily enough. But for now, it actually barely leaks at all, after just a drop or two of oil into the air adapter and cleaning the front two switch cups. And it really does RIP. I'm actually very tempted to see if I can tune the trigger a bit for a lighter pull, cuz it's rather snappy right now (1k smallbore lower tube, stiffer spring, and all), or use the higher-flow pin I've got in the parts kit and see if I could lighten the hammer spring a hair.
Posted 13 November 2008 - 01:15 AM
Posted 13 November 2008 - 10:40 PM
I figure 50-75 dollars to get that switch opened up, replaced, and timed isn't too horrifying, considering what the results should be. And hey, it's AFTER they ditched the tech that goofed the other guys' stuff, so I'm all good! Although, a switch rebuild kit is only $25... if only I can find a way to pound those seats outta there without scarring the body.
ooh... actually you have me thinking. What if I freon'ed the switch cups? Maybe they'd shrink up enough to pop right out. Or do cycles with freon and a torch to crack whatever grime layer is making them stick.
This post has been edited by flyweightnate: 13 November 2008 - 10:41 PM