There's a 99% chance that there's either too little lube or a bad o-ring in your HPR. Take it apart carefully and just lay things out on a clean, flat spot the same way they came out and check the o-rings. Once you take the HPR off, separate the upper part from the lower part then push the guts out of the top portion carefully. This section that comes out does not need to be taken apart. Just wipe off the o-rings, check them for cracks and re-lube them with either Militia Lube or Dow33.
Also, before you put it back together, check the red plastic reg seat in the bottom part of the HPR. If you can see noticeable damage to it other than just a little ring, take that out and flip it over. That part's a little tricky but just take it slow and be aware there's either 1 or 2 ball bearings underneath the reg seat.
the borg was teched before i got it
so i doubt it that
but the first day i had it it was shooting perfect
but can it affect something if the borg was runned lp and my tank is hp