Special Ops Paintball: SLG review thread - Special Ops Paintball

Jump to content


  • (3 Pages)
  • +
  • 1
  • 2
  • 3
  • You cannot start a new topic
  • You cannot reply to this topic

SLG review thread My thoughts on it.

#1 User is offline   light-u-up 

  • Everybody needs seizures!
  • PipPipPipPipPip
  • Group: Members
  • Posts: 2,252
  • Joined: 09-April 06
  • Gender:Male
  • Location:Orange, MA
  • Brigade Name:light-u-up

Posted 25 December 2007 - 06:36 PM

SLG, the super light gun. Truely speaks its name. The gun is light and tight. I tested it out on some reballs and some paint today. With the paint, I had alot of breaks. The paint was very brittle, and It could have been a problem with the dents. ( problems have been reported about the dents letting the ball roll forward) Those are going to be replaced as soon as I sell my phantom. The stock feedneck sound really be replaced. It is tiny. Its a real pain in the butt to change or move the ASA. Due to the built in rail you have to go through the grip to get to the pin that holds the asa in place. None the less the gun rips. I don't know how much I got it up on semi but psp ramp was A+. The hyper3 is much smaller than the hyper2, I wish I still had one lying around so I could compare the sizes but I don't anymore.

Now for the pics:

Posted Image

Posted Image
Hyper3
Posted Image

Hyper3 compared to reg on my cocker. Posted Image

NEw pics that have been asked for are finally up!!!

In the grip
Posted Image

Bolt and bolt guide
Posted Image

Eyes and Dents
Posted Image

This post has been edited by light-u-up: 08 February 2008 - 11:25 PM

0

#2 User is offline   light-u-up 

  • Everybody needs seizures!
  • PipPipPipPipPip
  • Group: Members
  • Posts: 2,252
  • Joined: 09-April 06
  • Gender:Male
  • Location:Orange, MA
  • Brigade Name:light-u-up

Posted 25 December 2007 - 08:45 PM

With the paint breaking issue. It must have been the cold weather. I was just shooting some paint in the basement, it worked fine. I was shooting ropes on semi. Then I did some reball shooting on Millenium, its like I had a non stopping yellow rope going across my basement. I belive I had it capped at 20 or so.
0

#3 User is offline   shadow_772 

  • Never compromise, even in the face of armageddon
  • PipPipPipPipPipPip
  • Group: Members
  • Posts: 4,272
  • Joined: 05-September 05
  • Gender:Male
  • Location:MA
  • Brigade Name:Shadow_772

Posted 25 December 2007 - 08:52 PM

Very nice. I like the silver a lot.
0

#4 User is offline   foozeball67 

  • Intergalactic Overlord of the United States of Wisconsin
  • PipPipPip
  • Group: Members
  • Posts: 693
  • Joined: 27-May 07
  • Gender:Male
  • Location:The Cheese State

Posted 26 December 2007 - 08:53 AM

so what would you rate this gun out of 10? I might get one, but I'm torn between this and a PMR.
0

#5 User is offline   SHRIMPED! 

  • Sophomore Member
  • PipPipPip
  • Group: Members
  • Posts: 295
  • Joined: 20-February 07
  • Gender:Male
  • Brigade Name:SHRIMPED!

Posted 26 December 2007 - 09:01 AM

Reballs chew up the stock nub detents... need spring loaded or magnetic ones. :D

And damn, that H3 reg looooooooooooks tiny... put me right off, glad I got my PMR. :)
0

#6 User is offline   light-u-up 

  • Everybody needs seizures!
  • PipPipPipPipPip
  • Group: Members
  • Posts: 2,252
  • Joined: 09-April 06
  • Gender:Male
  • Location:Orange, MA
  • Brigade Name:light-u-up

Posted 26 December 2007 - 09:30 AM

View Postfoozeball67, on Dec 26 2007, 10:53 AM, said:

so what would you rate this gun out of 10? I might get one, but I'm torn between this and a PMR.


Its really what your comparing it with. I'm going to base this off of any marker. Its not going to beat a marq or a dm8 but this on personal marker preferance.

Works:+5
Stock parts suck: -2
Rips: +1
Easy matince:+1
Cool new features:+2
Weight and looks: +1

Total of: 8/10
0

#7 User is offline   foozeball67 

  • Intergalactic Overlord of the United States of Wisconsin
  • PipPipPip
  • Group: Members
  • Posts: 693
  • Joined: 27-May 07
  • Gender:Male
  • Location:The Cheese State

Posted 26 December 2007 - 12:58 PM

you don't know if there'll be any upgrades out there for this soon, would ya?

and would the Dye UL grip frame fit on this?
0

#8 User is offline   light-u-up 

  • Everybody needs seizures!
  • PipPipPipPipPip
  • Group: Members
  • Posts: 2,252
  • Joined: 09-April 06
  • Gender:Male
  • Location:Orange, MA
  • Brigade Name:light-u-up

Posted 26 December 2007 - 02:31 PM

Theres already upgrades out.
Know all slg website
0

#9 User is offline   hunta93 

  • Forum Newbie
  • Pip
  • Group: Members
  • Posts: 41
  • Joined: 11-December 06
  • Brigade Name:hunta93

Posted 26 December 2007 - 02:33 PM

View Postfoozeball67, on Dec 26 2007, 12:58 PM, said:

you don't know if there'll be any upgrades out there for this soon, would ya?

and would the Dye UL grip frame fit on this?

the UL frame is comeing out later this year just get a rail before the price goes back up i got one yesterday for christmas and got my tank and hopper today and shoot have a couple beefs with it but the problems where user error and bad paint (i set the dwell too low and pulled a battery wire out :sick: )
proud member of TCP deathsquad sponsered in part by PCS paintball
http://forum.specialopspaintball.com/index...p;#entry1384382 plz buy!
0

#10 User is offline   The Hobbit 

  • Formerly Shadowlord
  • PipPipPipPipPipPip
  • Group: Members
  • Posts: 4,078
  • Joined: 15-November 05
  • Gender:Male
  • Location:Western PA

Posted 26 December 2007 - 07:53 PM

hey can you get pics of the internals and the noid/sear assembly?
Posted Image
0

#11 User is offline   Galihad 

  • Senior Member
  • PipPipPipPipPip
  • Group: Members
  • Posts: 1,027
  • Joined: 25-July 07
  • Gender:Male
  • Location:Oklahoma
  • Brigade Name:Galihad

Posted 27 December 2007 - 05:05 PM

View PostShadowlord, on Dec 26 2007, 08:53 PM, said:

hey can you get pics of the internals and the noid/sear assembly?


I'd like to second that, I'm really curious to tear one of these apart and see what makes it tick
Christian paintballers -beating the hell out of satan with tiny balls-
Sabre #117
My feedback!:click here
0

#12 User is offline   light-u-up 

  • Everybody needs seizures!
  • PipPipPipPipPip
  • Group: Members
  • Posts: 2,252
  • Joined: 09-April 06
  • Gender:Male
  • Location:Orange, MA
  • Brigade Name:light-u-up

Posted 27 December 2007 - 10:49 PM

I have the pictures of that. I just need to upload them, uploads will be tomarrow.
0

#13 User is offline   slinkyaroo 

  • Gravity takes over where brains leave off.
  • PipPipPipPipPipPipPip
  • Group: Administrators
  • Posts: 7,844
  • Joined: 08-February 06
  • Gender:Male
  • Location:Belleville, Ont Canada

Posted 27 December 2007 - 11:21 PM

OK light -- here's the big question. Since the PMR is now almost the same cost as the SLG. Why the SLG.


.
0

#14 User is offline   gameystar333 

  • Junior Member
  • PipPipPipPip
  • Group: Members
  • Posts: 855
  • Joined: 10-July 07
  • Gender:Male
  • Location:New Richland, MN
  • Brigade Name:PYROPAINTBALLER

Posted 27 December 2007 - 11:25 PM

how much for the phantom i may buy it
guy "How come you guys didn't arm the bomb"
aimforthetrash "because we all died"
my crowning forum achhivement
Feedback here soon.
I support Mike and TechPb. Put this in your sig if you do too.
0

#15 User is offline   Galihad 

  • Senior Member
  • PipPipPipPipPip
  • Group: Members
  • Posts: 1,027
  • Joined: 25-July 07
  • Gender:Male
  • Location:Oklahoma
  • Brigade Name:Galihad

Posted 27 December 2007 - 11:27 PM

it has a hyper 3 instead of a hyper 2?

maybe it has slightly better effeciency?

slightly lighter maybe?

who knows... maybe people want a sear tripper??
Christian paintballers -beating the hell out of satan with tiny balls-
Sabre #117
My feedback!:click here
0

Share this topic:


  • (3 Pages)
  • +
  • 1
  • 2
  • 3
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users