Special Ops Paintball: X-valve spydermag cycling too slow - Special Ops Paintball

Jump to content


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

X-valve spydermag cycling too slow Rate Topic: -----

#1 User is offline   gunhand 

  • gunhand
  • PipPipPipPip
  • Group: Members
  • Posts: 878
  • Joined: 09-December 05
  • Gender:Male
  • Location:West Virginia, charleston
  • Brigade Name:gunhand

Posted 20 December 2008 - 09:32 PM

I am having trouble with my mag cycling. it seems that there is a unusually long delay between me pulling the trigger and the gun actually firing, and I cannot seem to get it to cycle much faster than 7 or so bps, I am puzzled by all this. Anyone know what is going on. I have tried the different springs and chronoed the gun and it is shooting consistent and all, just not getting the ROF it should.

here are the specs on it:
ule body
ULT kit
level 10
spydermag modded frame done by Luke
spyder t board

dont know whats wrong and appreciate any and all help ;)
WVU Tech Mechanical Engineering. Class of (should be 2009, but its not!)

Specops Feedback

FBM KRUSHER E-COCKER FS, NEED MONEY FOR SCHOOL
0

#2 User is offline   LoveMyMagMoreThanYou 

  • CPPA #1875
  • PipPipPip
  • Group: Members
  • Posts: 688
  • Joined: 27-October 05
  • Gender:Male
  • Location:Sedro-Woolley, WA
  • Brigade Name:Undying

Posted 20 December 2008 - 11:23 PM

Well, first thing that I would do is try a mecanical frame to isolate the problem between the valve system and the trigger frame. Do you have a mechanical frame or at least access to one?
0

#3 User is offline   gunhand 

  • gunhand
  • PipPipPipPip
  • Group: Members
  • Posts: 878
  • Joined: 09-December 05
  • Gender:Male
  • Location:West Virginia, charleston
  • Brigade Name:gunhand

Posted 21 December 2008 - 07:03 AM

nope, unfortunately I'm the only person I know who has a mag. And the sear has been highly modified, so a mech frame wouldnt work anyhow.

the electrtonics seem to cycle at full speed when not under the load of the pneumatics, I am going to try a different battery and I need to look closely at the dwell settings and stuff on the board, to see if they have gotten messed and/ or reset.

The gun cycled fine when I got it, and when I took it down to clean it and inspect all the o-rings and stuff it started leaking. So I started at the begening and went through the procedure to tune the level 10, it works now and will not chop a ball or anything.

But my question is: Can improper setup cause the gun to act like this? Would improper setup of the ULT on/off cause this?

Thanks
WVU Tech Mechanical Engineering. Class of (should be 2009, but its not!)

Specops Feedback

FBM KRUSHER E-COCKER FS, NEED MONEY FOR SCHOOL
0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users