This post has been edited by The Elder: 20 May 2008 - 08:27 PM
Posted 20 May 2008 - 08:26 PM
Posted 20 May 2008 - 10:25 PM
I have the answer, but it requires Permanent Removal of the X7's Cyclone by snapping off the Feed Arm on the Right Body of the X7 or by another X7 Right Body Half and snap off the Feed Arm.
Other than that, get a Tac Cap for your X7.
This post has been edited by Evil Fingers: 20 May 2008 - 10:26 PM
Posted 21 May 2008 - 07:58 AM
Number of downloads: 81
What do you know. Let me know if this works and I'll send more pics.
As you can see I used two separate pipe sections so I could maintenance it (if I ever use it). One pipe section holds the spring in when coked and the other section has the grove, and locking notch, and feed hole carved out. The spring is that of a note book binder. I made the bolt out of a marker cap that fit snug in the spring, I put a screw in the marker cap so that the tip barley went through the other side, Then I put a few layers of tape around the front of the cap so it fit the pipe well. I filled the cap with a piece of a rope so the paint-balls wouldn't get wedged. I'm planing on replacing the tape that is holding the pipe sections together with shoo goo because it will look better and can still be taken apart. If you look carefully you can see the feed hole on the opposite side.
This post has been edited by The Elder: 21 May 2008 - 02:25 PM
Posted 22 May 2008 - 04:45 AM
Nothing is permanent if you have some JB Weld!
Posted 22 May 2008 - 08:17 AM
J&B Weld doesnt hold very well when used sparringly.
Posted 26 May 2008 - 05:49 PM
This post has been edited by Chaos: 26 May 2008 - 05:50 PM