Special Ops Paintball: Infamous Timmy Problem - Special Ops Paintball

Jump to content


  • (2 Pages)
  • +
  • 1
  • 2
  • You cannot start a new topic
  • You cannot reply to this topic

Infamous Timmy Problem Stuck on full auto and choppin like crazy

#1 User is offline   TS0716 

  • Senior Member
  • PipPipPipPipPip
  • Group: Members
  • Posts: 1,743
  • Joined: 06-September 05
  • Gender:Male
  • Location:New Jersey
  • Brigade Name:TS0716

Posted 10 January 2008 - 02:17 PM

Ok, well i just went to the proshop and got my tank filled and the o-ring on the ram replaced, so the old leak problem is gone.

I took it out back, aired it up and dry fired for a little bit, no problems.

I put my hopper on it, turned it on, turned the eyes on and let it rip

It shot pretty consistently for about 20 shots, then the gun became stuck on full auto. It pretty much emptied the hopper, and left it like this

Posted Image

Once the balls stopped it feeding, it kept on shooting. I took the hopper off and checked the gun out. eyes were clear. The LPR was set to 75 psi, so i turned it down to 50. When i had it at 50, it sounded too quiet, as if it wasn't cycling fully. So i turned it up till it sounded normal, which was at 60 psi. I dry fired again, no problems. Put the hopper back on it with paint, started shooting, and it went full auto on me again until i pretty much ran out of air in the tank.

I have no clue what the problem could be. Last time i went to the field it shot fine. When i was shooting, it didn't look hot, but it may be the HPR is too high, but i don't have a gauge for it. I heard the LPR should be set for 50 psi on an infamous, but the gun just doesn't sound like it is cycling at 50 psi.

Here are my settings:

Debounce: 1
Dwell: 10
Anti-bounce: 3
ABS: 3

Virtue board btw. Any help would be appreciated.
0

#2 User is offline   slinkyaroo 

  • Gravity takes over where brains leave off.
  • PipPipPipPipPipPipPip
  • Group: Administrators
  • Posts: 7,840
  • Joined: 08-February 06
  • Gender:Male
  • Location:Belleville, Ont Canada

Posted 10 January 2008 - 02:30 PM

First I will say - I've had 3 timmies and 2 DF's so this might sound funny but it's true....


Change the battery. other than that check the trigger and switch.



.

This post has been edited by slinkyaroo: 10 January 2008 - 02:36 PM

0

#3 User is offline   TS0716 

  • Senior Member
  • PipPipPipPipPip
  • Group: Members
  • Posts: 1,743
  • Joined: 06-September 05
  • Gender:Male
  • Location:New Jersey
  • Brigade Name:TS0716

Posted 10 January 2008 - 04:42 PM

haha. I took the battery out and put it back in a min later. now it works. thanks

board must have locked up
0

#4 User is offline   The Hobbit 

  • Formerly Shadowlord
  • PipPipPipPipPipPip
  • Group: Members
  • Posts: 4,078
  • Joined: 15-November 05
  • Gender:Male
  • Location:Western PA

Posted 10 January 2008 - 07:48 PM

you hopper looks yummy man. LOL
Posted Image
0

#5 User is offline   blackraven64 

  • What more do you want?
  • PipPipPipPipPip
  • Group: Members
  • Posts: 1,967
  • Joined: 06-October 05
  • Gender:Male
  • Location:Ocala,Florida
  • Brigade Name:BlackRaven

Posted 10 January 2008 - 08:55 PM

good luck with that hopper man.

halo disassembly ftl.
0

#6 User is offline   slinkyaroo 

  • Gravity takes over where brains leave off.
  • PipPipPipPipPipPipPip
  • Group: Administrators
  • Posts: 7,840
  • Joined: 08-February 06
  • Gender:Male
  • Location:Belleville, Ont Canada

Posted 10 January 2008 - 09:15 PM

TS - your battery's cooked. 2K5 and up timmies are the only markers I know with this probalem - not DF's, 2K2 or any other markers.


I believe it's the required power to the noid since that draws the most power but I only have this problem on the field and with people that have no manual and have to figure things out but memeory. You're batteries done. Change it. Or bring a back up battery to the field.



.

This post has been edited by slinkyaroo: 10 January 2008 - 09:18 PM

0

#7 User is offline   Marauder_Pilot 

  • Thrilling Heroics
  • PipPipPipPipPipPip
  • Group: Members
  • Posts: 3,237
  • Joined: 10-May 06
  • Gender:Male
  • Location:Whitehorse, Yukon
  • Brigade Name:Marauder_Pilot

Posted 11 January 2008 - 08:02 AM

View Postblackraven64, on Jan 10 2008, 08:55 PM, said:

halo disassembly ftl.

Indeed. Those things suck, I can't wait until I've got the monies for a Magna.

This post has been edited by Marauder_Pilot: 11 January 2008 - 10:51 AM

0

#8 User is offline   motoguy1251 

  • Mustache Afficianado
  • PipPipPipPipPip
  • Group: Members
  • Posts: 1,517
  • Joined: 11-April 06
  • Gender:Male
  • Location:Big Rapids MI
  • Brigade Name:motoguy1251

Posted 11 January 2008 - 08:10 AM

Man that hopper is taost.

Take electronics out and hose.
1Ill be on you like white on rice in a glass of milk on a paper plate in a snow storm!!
2Games: Americas Army, Battlefield 2,2142,1942,vietnam,Fear, CSS,Red Orchestra,DOD, Oblivion,GaryMod,more
0

#9 User is offline   TS0716 

  • Senior Member
  • PipPipPipPipPip
  • Group: Members
  • Posts: 1,743
  • Joined: 06-September 05
  • Gender:Male
  • Location:New Jersey
  • Brigade Name:TS0716

Posted 13 January 2008 - 04:52 PM

hah that hopper was a pita to clean, but it got done. I got a new suicide shell in the mail while i was in the middle of cleaning it, so that was a plus.

I almost hosed it down, but i didn't wanna foul up the motor. I just used about half a roll of paper towels though. (sorry trees :rolleyes:)
0

#10 User is offline   willdunn 

  • *INSERT CATCH PHRASE*
  • PipPipPipPip
  • Group: Members
  • Posts: 916
  • Joined: 19-December 06
  • Gender:Male
  • Location:Austin, Texas
  • Brigade Name:willdunn

Posted 27 January 2008 - 12:41 AM

I dont understand why your halo would do that, do you have an empire? its just weird that the balls would chop in the hopper like that...

willdunn
0

#11 User is offline   SHADOW SNIPER 

  • masta of disasta
  • PipPipPipPipPip
  • Group: Members
  • Posts: 1,087
  • Joined: 10-April 05
  • Location:dirty jersey
  • Brigade Name:shadow sniper

Posted 27 January 2008 - 07:53 PM

hey bro long time no talk. well your batts. and your board is problly fried unless you really dont know how to change modes ad ur debounce higher idk but if someones that stupid u might think thats fully auto. anti bounce raise to 4-5 all i can think of this second besides why a timmy
www.zjpaintball.com
FREE AGENT
Rangerz ego7 sling trigger zick kit
0

#12 User is offline   French 

  • Group:Banned
  • PipPipPipPipPipPipPip
  • Group: Members
  • Posts: 6,333
  • Joined: 05-November 06
  • Gender:Male
  • Location:Mississauga.ont CANADA
  • Brigade Name:QC MAD KID

Posted 27 January 2008 - 08:35 PM

View Postwilldunn, on Jan 26 2008, 11:41 PM, said:

I dont understand why your halo would do that, do you have an empire? its just weird that the balls would chop in the hopper like that...

willdunn

it a halo b eye's it sucks
INFLUENCE 09 Vaughan Vipers RXL 2k10
WARNING HEAVY METAL click me /Here my feedback
Tdot feedback Group banned# 13 MCB feedback
0

#13 User is offline   willdunn 

  • *INSERT CATCH PHRASE*
  • PipPipPipPip
  • Group: Members
  • Posts: 916
  • Joined: 19-December 06
  • Gender:Male
  • Location:Austin, Texas
  • Brigade Name:willdunn

Posted 27 January 2008 - 08:44 PM

yea, but your paint would have to be pretty dark for it to do some thing like that
0

#14 User is offline   kellts 

  • OG.
  • PipPipPip
  • Group: Members
  • Posts: 385
  • Joined: 28-November 05
  • Gender:Male
  • Location:Tucson, AZ
  • Brigade Name:Kellts

Posted 28 January 2008 - 03:57 PM

View Postwilldunn, on Jan 27 2008, 09:44 PM, said:

yea, but your paint would have to be pretty dark for it to do some thing like that


I'm with you. A Halo's eyes suck, but they suck at seeing movement. They don't have trouble with balls sitting in the stack..

It's gotta be a Reloader..
0

#15 User is offline   Pirate 

  • I aim to misbehave.
  • PipPipPipPipPipPip
  • Group: Members
  • Posts: 3,592
  • Joined: 17-February 05
  • Gender:Male
  • Location:The Fight Four Oh!
  • Brigade Name:PirateCaptain

Posted 05 February 2008 - 09:43 PM

You know, if you had a Pinokio hopper, that wouldn't be hard to clean at all.
(This is a plug for Pinokio hoppers).

Seeing as the problem has been solved, I'll only suggest you up the DeBounce a little.
My job is to be an asshole. I excel at the position.
We put our glass to the sky and lift up. And live tonight 'cause you can't take it with ya. So raise a pint for the people that aren't with us. And live tonight 'cause you can't take it with ya...
Austin Michelle Cloyd, Forever in my heart. We love you, Ayesha! Rest in Peace Tyler Hackett
Rest in Peace, Dave Brockie! Cam Cam #83
0

Share this topic:


  • (2 Pages)
  • +
  • 1
  • 2
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users