Virtue settings on an Ego5 How to get it to diff modes???
Posted 22 March 2008 - 06:20 AM
Posted 22 March 2008 - 06:53 AM
this might help also
Installing a Virtue Board is extremely easy
Open up the grip from the right side of the marker to expose the board.
Carefully remove the battery, and disconnect the solenoid and eye wires.
Remove the 3 screws holding the stock board in place, and remove the stock board.
Connect the solenoid and eye wires to the Virtue Ego board.
Place the Virtue Ego board into the gun so the buttons and LED line up with the 3 holes in the back of the grip frame.
Screw the Virtue Board back into place with the 3 screws removed in step 3.
Connect the battery, close the grips, and destroy the competition.
If you want to change the debounce to 2 you would:
With the marker off, and Dipswitch 2 in the on position, hold the trigger and turn the marker on.
The LED will now cycle through a rainbow of colors and stop on purple.
Tap the trigger once so the LED glows green.
Pull and hold the trigger until the LED starts to flash (factory default for debounce is 5, so the LED will flash 5 times).
When the LED stops flashing, quickly tap the trigger 2 times.
The LED will now flash 2 times, and then flash through the rainbow of colors, and stop on green, indicating the new value has been set.
To exit programming mode, shut the marker off.
Programming LED Colors
With Dipswitch 2 in the on position, hold the trigger and turn the marker on. The LED will then cycle through a rainbow of colors and stop on purple. Tapping the trigger will then toggle through the different programming modes:
Programming Mode Color
Firing Mode Purple
Ramp Activation Speed Blue
Ramp Percentage White
Eye Sensitivity Teal
AMB (Anti-Mechanical Bounce) Yellow
ABS (Anti-Bolt Stick) Flickering Green
Max Rate of Fire Flickering Red
Technical, Warranty and Support Information
Product Manual (PDF)
30 Day Money Back Guarantee
Contact Service and Support
http://home.virtuepa...virtueEgo05.pdf <--- Manuel
This post has been edited by Shadowlord: 22 March 2008 - 06:58 AM
Posted 22 March 2008 - 06:18 PM
Posted 22 March 2008 - 09:45 PM
Pull and hold the trigger. Turn marker on. You are in programming mode.
First mode is firing mode.
Release the trigger then hold it in. The LED should flash xxxx times. xxx= mode. one flash is semi.
Right after it stops flashing pull the trigger the equivalent amount of times to get to the mode you want. I think response is 5 pulls.
The LED wll flash to confirm the setting. Turn marker off.
BTW - YOU CANNOT ENTER PROGRAMMING MODE IF ON TOURNEY LOCK.