two, this statement:
"As for the "stronger plastic" issue, I think I addressed that in the previous post..."It would also have to be a bit thicker than normal on the "larger" side". You apparently didn't read that part. I've thought this whole thing through fairly extensively, almost to the point of building prototypes myself, just to have an offset hopper that everyone seems to think is available, but really isn't. At least not one that I would consider truly "offset"."
okay I was addressing your stronger plastic issue that was excatily what I was referring to!!! re read my post before posting next time! Sorry I didn't say thicker , but thats what I was talking about...
a hopper wouldn't need to be thicker or stronger in a certain spot more then another spot.
also I wasn't calling you a noob...
theres a difference between noob and NEWBIE, okay sorry for insulting you if I did...
I won't say anything else in till you can tell me if you were talking about the 'feed neck' that is factory installed on a MARKER
or if you mean when you look at a HOPPER all by its self... the tube that the balls drop out of.
I didn't mean to insult you or anything. The way I read your post I wasn't sure if you meant like making the gun so the feedneck is to the left or right of the gun OR, making a hopper so the majority of the hopper is hanging out over open air on the left or right or left of the gun.
When I read other peoples posts in this thread they were talking about the factory making the feedneck sit off to the side like on the x7.
This post has been edited by rebaler: 02 June 2008 - 04:51 PM