Special Ops Paintball: Changing eRex feed neck - Special Ops Paintball

Jump to content


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Changing eRex feed neck

#1 User is offline   KevinR 

  • Forum Newbie
  • Pip
  • Group: Members
  • Posts: 7
  • Joined: 12-February 09
  • Gender:Male
  • Location:Capital Region of NY

Posted 18 February 2012 - 04:57 AM

I need a little advice---

First, I have a eRex electric semi, I want to use it to create a M40a3 style rifle (later conversion to bolt action).
I want to change from the standard feed neck to a 10 or 20 round spring fed magazine similar to the RAP4 T68/PT Jr/G2 or the BT SA-17.

Problem converting the neck. Or just removing it, adding an offset rail and mag.
Want to maintain as low a profile as possible. (trying to keep appearance of scope)
Any advice?

Attached File(s)


This post has been edited by KevinR: 18 February 2012 - 04:59 AM

0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users