My first idea is to narrow the outside of the mask and attach it closer to the head. That extra room between the jaw and the mask, In my opinion, is useless. This is primarily for a sniper so moving around would be like wearing a ski mask. Anyway, I would cut out a section and melt the material closer. I'm not sure if it will work.
My other idea is to cut out a section of the side and extend the lens using a couple sheets of fiber glass.I think it would be easier to make a sort of swining lens so I can look down the sights with two places of protection, 1 on the inside of the mask, and the swing lens. Sort of like a scope.
I think it's crazy and doubt if it will work but If you can carry it out be my guest. It's a working progress, I'll post some pictures once I get done with my first prototype. Wish me luck.
This post has been edited by Veritas1992: 15 September 2007 - 12:38 PM