Special Ops Paintball: Rail mount on the sides of the blackcell q-bow - Special Ops Paintball

Jump to content


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Rail mount on the sides of the blackcell q-bow Rate Topic: -----

#1 User is offline   Link Spartan 

  • Forum Newbie
  • Pip
  • Group: Members
  • Posts: 16
  • Joined: 20-May 07
  • Brigade Name:Link Spartan

Posted 18 June 2008 - 11:33 AM

i had gotten these rail mounts for my blackcell ion. and i really dont know how to put them one.

i cant just screw it in its way too hard to.

anyone know how to get these things on the gun?

http://www.specialopspaintball.com/shop/pr...p;CAT=107208302
0

#2 User is offline   Tommikka 

  • Tom
  • PipPipPipPip
  • Group: Members
  • Posts: 811
  • Joined: 28-May 07
  • Gender:Male
  • Location:Salisbury, UK
  • Brigade Name:tommikka

Posted 18 June 2008 - 12:47 PM

View PostLink Spartan, on Jun 18 2008, 07:33 PM, said:

i had gotten these rail mounts for my blackcell ion. and i really dont know how to put them one.

i cant just screw it in its way too hard to.

anyone know how to get these things on the gun?

http://www.specialopspaintball.com/shop/pr...p;CAT=107208302

You need to drill holes first, look for the existing marker points, then drill with the size as below, or if you are not too confident start with a smaller drill bit.

Quote

NOTE: Side rail mounting requires drilling pilot holes for screws. See the instructions below.

Tools required to mount side rails:

5/64-inch drill bit
Drill
Philips head screw driver

Instructions
1. Locate the "dimples" on both sides of the marker body (located near the front).
2. Using a 5/64-inch drill bit, drill through the dimples in the body.
3. Attach the rails using the four (4) screws provided.

This post has been edited by Tommikka: 18 June 2008 - 12:49 PM

0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users