Possible leak on a phantom
Posted 31 October 2007 - 07:25 PM
Anyway, when I clean it and put it back together the body and valve (this is a VSC) don't meet as snug as they did. I took it apart and put it back together while pressing the body hard against the valve, and yet after pumping a few times it goes back to a gap.
Mind you, this gap is very small (almost a mm... maybe). Would this cause gas to leak out? or is this normal?
I didn't try to shoot it again, as im out of 12 grams >.<
Posted 02 November 2007 - 11:16 AM
Make sure you dry the gun though.
Pump Discussion Thread
Looking for a jungle sunset micromag
Posted 02 November 2007 - 11:59 AM
And if you have a plain black pump handle, not the acrylic ones, take it off before you do that and make sure the pump arm is dry, cause it will swell. Not a lot, but enough to make your life a little more difficult when trying to screw the pump handle back on.
Though that gap is fine. The only problem a gap there will cause is the inability to cock the marker, but only with a Big gap.
I'm back from a long long long time of no paintball, drooling over markers older then I am.
Posted 04 November 2007 - 11:48 AM
^I think I'll just leave it that way. It suits me.
Posted 04 November 2007 - 08:35 PM
My teams home field, take a look, especially if your from Mississippi