I picked up a used Mini and I replaced the solenoid. I aired it up, it started leaking, and it made a loud bang, the poppet seating/sealing I'm assuming, and then kept leaking. I hooked a remote up to it to gently increase the amount of air going into the marker. It leaked out the barrel at first, and then out of the gas transfer tube area, and now it leaks directly out of where the reg meets the gas transfer tube. My other problem is that the pressure on the reg jumps to over 400psi even before the remote is all the way screwed in and the gold screw (adjusts pressure) is flush with the front of the reg. It should be around zero until I screw it in more, it rockets to over 400psi still. The o-ring on the bottom of the tube is fine, and the regulator is flush with the bottom of the grip frame. Any ideas?
EDIT: After school I'll try a fresh battery, and reconfirm that everything is lubed properly and screwed in properly and whatnot. Should I maybe take the regulator apart and make sure things are alright in there? I'd need direction though.
This post has been edited by TyTy: 17 February 2009 - 07:34 AM