Special Ops Paintball: hpa caps - Special Ops Paintball

Jump to content


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

hpa caps Rate Topic: -----

#1 User is offline   TeleFragger 

  • Forum Member
  • PipPip
  • Group: Members
  • Posts: 184
  • Joined: 01-September 09

Posted 19 March 2010 - 04:29 PM

ok so i have 3 hpa tanks now..

45/88/88-4500's

well they dont have a cap on the little nubb.. fill part i guess... still newbin it...

anyway I got these blue annod ones that have rings...
well i guess you unscrew the nipple and place it through it..

so how do you verify all air is out of the tank?
is it safe to push the pin in on the top of the tank?

thanks for helping me not hurt myself or others...
__________________________________
98C==>Rap4 Stock (6 position)==> RT==> End Game Compression Barrel==> Cyclone Feed==>Tac Cap and x7 Low Prifile Hopper==> 45/88/88-4500 tanks ==> dye i3 mask==> remote line
Side Arm==>Tiberius Tac 8.1 with 4 first strike mags and 6 regular mags
Specops Custom Vest - pistol holster w. extra clip/tons of pod holders/extra mags holder (pics when it gets here!!!!)
*********Feedback**** click on a link below
-------Specops-------------MCB
0

#2 User is offline   Mehphisto 

  • JUST A SMALL TOWN GIRL
  • PipPipPip
  • Group: Members
  • Posts: 454
  • Joined: 24-January 10
  • Gender:Male
  • Location:LIVING IN A LONELY WORLD

Posted 19 March 2010 - 05:34 PM

If you have an on/off ASA you can just take the macro off of it and then turn the ASA on. If you have a remote just leave it so the end isn't connected to anything and let the air go out of it. If you don't have any other options you can just push the pin on the top in. Make sure that all the air is gone before you try to take off the fill nipple.
Damn it feels good to be a gangster.

ELITESPORTS OT
The only original OT team
0

#3 User is offline   Dark Shadow Hunter 

  • Screwball, one each.
  • PipPipPipPipPipPip
  • Group: Members
  • Posts: 2,502
  • Joined: 10-December 06
  • Gender:Male
  • Location:Michigan
  • Brigade Name:Dark Shadow Hunter

Posted 30 March 2010 - 09:38 AM

Mehphisto's methods are best. If you are using an on/off ASA or a remote line, I recommend keeping it attached while you remove the fill nipple. Also make sure you remove it slowly. There is always the chance of some residual pressure, even if the gauge reads zero.
0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users