Special Ops Paintball: My new egg doesn't fit!! - Special Ops Paintball

Jump to content


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

My new egg doesn't fit!!

#1 User is offline   celeron 

  • Forum Newbie
  • Pip
  • Group: Members
  • Posts: 22
  • Joined: 01-June 07
  • Gender:Male
  • Brigade Name:Celeron

Posted 15 August 2008 - 11:56 AM

What feedneck would fix this? I run a stock ION.
0

#2 User is offline   UWANNAGO 

  • Im kind of a big deal, people know me
  • PipPipPipPipPipPipPip
  • Group: Moderators
  • Posts: 6,841
  • Joined: 02-August 05
  • Gender:Male
  • Location:So Cal/Alabama
  • Brigade Name:UWANNAGO

Posted 15 August 2008 - 11:58 AM

Any clamping feedneck or just sand down the neck on the ion.

If your looking to jury rig it you can just take the orings out of the feedneck and jam the hopper in.

Peace,
Teddy K
0

#3 User is offline   Rattlesnake 

  • Klapperschlange
  • PipPip
  • Group: Members
  • Posts: 125
  • Joined: 08-November 07
  • Gender:Male
  • Location:Smiths Station, AL
  • Brigade Name:{[D4]}The Rattlesnake

Posted 15 August 2008 - 12:23 PM

I would suggest getting a clamping feedneck anyways...It'll keep your hopper from wiggleing around everywhere

at least, and preferably on top of a clamping feedneck, I would take some 200-250 grit sandpaper, and wrap it around the feedneck of the hopper itself...then just twist it around to thin it out a bit...After that I'd prolly take a smoother grit...say 750-800 and smoothen it out a bit.

I had to do it on my Empire Reloader B

as for feednecks, I would go for either a Shocktech, or a Lapco Low Rise...you might have seen my thread around here on that sublect...my QLock bent it's way out, so if you play really agressive, I'd get one of those...I'm trying to figure out which one is "better" so...yea

in short - pickup a clamping feedneck, and sand down the outside of the feedneck of the hopper...

-peacezilla
0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users