CP roller trigger on an Ion
Posted 04 August 2006 - 03:12 PM
Either way, onto the trigger. I purchased this earlier in the week, but today's the first time I've sat down and made adjustments and tweaked it to my liking. I adjusted it to where the trigger travel was quite short, just barely continuing after it clicks to fire. Once I got it dialed in, I had a blast walking all over this trigger. It's very comfortable to shoot, the shape is quite nice, and it flows very well. There's no resistance, and no delay on the return. The bearings in this trigger work fantastic.
The ONLY gripe I have with this trigger (and this is mostly my fault) is the install. When I tried to install it, I could not get the spacers turned the right way, because you're supposed to have the tapered side facing the bearing. Well my eyes aren't the best, so it took some time for me to get it right. Like I said, that's my own problem, and not the trigger's. However it would be nice if they put an indicator on the spacers showing which was the tapered side.
All in all, I would say this trigger is a good buy and I'd recommend at least trying, if not buying one.
Posted 05 August 2006 - 10:17 AM
"Political correctness is a doctrine, fostered by a delusional, illogical minority, and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end."
Posted 07 August 2006 - 09:34 PM
Posted 09 August 2006 - 09:57 PM
I'm not using loc-tite on mine, and it's working just fine. The screw hasn't come loose yet /knocking on wood.