Custom Automag APE Rampage E-Pneumag
ULE Warp Left main body -Black
Classic Rail -Black
15 Degree For-grip adapter
Bicycle grip -Black
Intel Frame -Chrome Customized for E-Pneumatic conversion.
30 degree drop
CP 14" 2 piece- gloss back and dust front
Warp-Feed with duel 9v mod -Smoke(can add a 12v mod as well)
All parts for mounting warp-feed
Macro-line and fittings as you see it
Now on the the good stuff..
Custom APE Rampage A5 board (Wired to run off the warp-feed. This keeps the amount of batteries needed to run this setup down. I was going to wire in my revy to but have run out of time)
SMC PM3 solenoid
Clippard MPA-3 air piloted actuator
Custom Air fittings for Actuator to Solenoid
Palmer's Rock LPR
All hoses, fitting, wiring, and so on,to make it run..
It can be reverted to mechanical in about 10 minutes but would take a while to put the electronics back in after
I can throw in my custom molded Revy to If you want it.....
Here are the pics of what you will be getting
<a href="http://www.shatteredangelspaintball.com/pics/sale/mag5.jpg" target="_blank">
</a>a little video of it in action at Oregon SPPL 2007
The trigger has a little side slop but I don't notice. Also she is finicky about screw presser.
This is my Baby and want it to go to someone that will take care of her..
Sorry no trades unless its a killer one
Have good Ebay feedback and I'm sure that I can get more than one person from around these parts to vouch for me
This post has been edited by saber: 15 November 2007 - 07:18 PM