98 Custom Platinum Problems
Posted 04 December 2008 - 03:33 PM
Bought it because I like the line. (shh)
But I am having serious problems putting the gas line that has that big hex nut back in the marker without having it spew out air when I put a tank on. I literally have been turning the hex nut slowly and testing it out then turning it again and testing it. Is there something I am missing?
Posted 04 December 2008 - 03:49 PM
Posted 04 December 2008 - 03:58 PM
Its a self (sticking) power tube and gas line.
Worked great until I played a few games and took it apart and cleaned the marker. Cleaned tons of different Tippmann markers before and had them working great afterwards. This one though...
Number of downloads: 24
Posted 04 December 2008 - 11:16 PM
AS for the powertube problem i had this also, place the hex nut in the groove it fits in and push it against the powertube then reassemble the marker
Now take and screw in your tank slightly just enough to allow gas into the gun then, take a crescent wrench tighten the silver part outside until you cannot hear the air leak any longer then fully charge your gun and fire off and tighten as need be, dont overtighten if its having problems stilltake apart the gun and make sure everything is seated correctly.
Posted 12 December 2008 - 01:39 PM
In general, on my 98C Platinum, I just place the tube in, screw the hex by hand at a leisurely torque, and close up the side, ensuring that the connection is straight on. I then use a crescent wrench and tighten the hex. Works everytime.
Posted 20 May 2009 - 03:23 PM
Posted 21 May 2009 - 09:48 PM