So: an unfortunate update...
Yes, the fill nipple was leaking. Unfortunately, a standard fill nipple could NOT fit into the regulator. We also tried using the pin from the new one in the old nipple, to no avail.
So...basically, I figure I'll have to get a new regulator. But then, I thought, what if a new regulator doesn't fit? I was thinking it would be simplest (and more reliable) to just call up Ninja and ask them to preset a 4500psi reg for a higher than normal (800 psi) output.
1) Does anyone know if the Worr Gas tank I have is going to fit other regs? I can't find more detailed information than this: http://www.directpai...tems-P6397.aspx
2) What, in your experience, is a good working output pressure for a Tac One Automag (ie. 1100 psi)?
3) I've read that past a certain output psi (1000?) I should have the 1.5k burst disk replaced with a 3k burst disk. Is that a good idea? And does it hurt the reg to reduce the output to below that level once the burst disk is replaced?
Unfortunately, I do not have money at this time to buy a brand new HPA tank, and my original one is just a 48/3000 PE steely, which is not adjustable to my knowledge (plus it's not much air, particularly for a mag).