Special Ops Paintball: e trigger - Special Ops Paintball

Jump to content


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

e trigger Wont actuate bolt Rate Topic: -----

#1 User is offline   nostrum 

  • Forum Newbie
  • Pip
  • Group: Members
  • Posts: 5
  • Joined: 30-June 06
  • Gender:Male
  • Location:Colorado
  • Brigade Name:Nostrum

Posted 23 February 2008 - 03:08 PM

So I got my new ACT 98 pro and I installed the E-trigger today. Everything is working okay except the bolt will not fire. I messed with my dwell rate, and set that as high as 50ms. The only way I can get the bolt to fire is by pulling back a bit, and holding it there while I fire the trigger.

Please help.
0

#2 User is offline   slowerpig81 

  • This man is a Beast with that Phantom. -thisissparta
  • PipPipPipPipPip
  • Group: Members
  • Posts: 1,528
  • Joined: 23-November 07
  • Gender:Male
  • Location:St. Louis, MO
  • Brigade Name:slowerpig81

Posted 23 February 2008 - 11:53 PM

Do you have a fresh battery? That is usually the problem. Changing the dwell will not make a difference, unless it is way too low.
Oil your sear, and the rod that goes from the soleniod.
Call tippmann if that doesn't work.
0

#3 User is offline   nostrum 

  • Forum Newbie
  • Pip
  • Group: Members
  • Posts: 5
  • Joined: 30-June 06
  • Gender:Male
  • Location:Colorado
  • Brigade Name:Nostrum

Posted 24 February 2008 - 03:15 PM

View Postslowerpig81, on Feb 24 2008, 01:53 AM, said:

Do you have a fresh battery? That is usually the problem. Changing the dwell will not make a difference, unless it is way too low.
Oil your sear, and the rod that goes from the soleniod.
Call tippmann if that doesn't work.


Thanks, I replaced the battery with a fresh duracell and no luck. I contacted tippmann, but have to wait for a response.
0

#4 User is offline   slowerpig81 

  • This man is a Beast with that Phantom. -thisissparta
  • PipPipPipPipPip
  • Group: Members
  • Posts: 1,528
  • Joined: 23-November 07
  • Gender:Male
  • Location:St. Louis, MO
  • Brigade Name:slowerpig81

Posted 24 February 2008 - 05:49 PM

Oil the parts, and make sure the receiver bolts aren't too tight. It's possible that your drive spring is too strong because it's new. You might try leaving it cocked for 6 hours or so, and if it doesn't work then leave it cocked overnight. If the spring is too strong, it might be pushing the hammer (rear bolt) too hard against the sear, and causing too much friction for the soleniod to unlatch it from the hammer.

Can you make it fire if you pull the trigger many times?
0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users