This post has been edited by Evil Fingers: 09 May 2006 - 10:45 AM
Slide Check is leaking badly Here's the solution!
Posted 15 May 2006 - 01:46 PM
where could i purchase one of the on/off switches you used to replace the slide check?
Posted 06 June 2006 - 12:05 AM
32Degrees is okay in my books, cause DUMPER happens and they took care of it. ...
I'm going to have to disagree with you based on my latest experience with 32░.
My 32░ slide check was chopping little circles out of the front o-ring like a lot of other people. So, before I tried any ideas of my own, I thought I'd email 32░ directly. First of all, I asked 2 questions & they only answered 1 part where I asked to confirm my assumption about using tank o-rings as replacements. So, I had to email them again, with the same 2nd question. Their only idea was to oil it. Ya, great, I never thought of that, already did that. Chop Chop.
So, I whoever is manning thier "tech" email blows.
I went ahead with my first thought, which was the same as is posted on here, chamfering the edges of the holes. It works like it should, great. So, oh well. It's just too bad that 32░ doesn't always ship them out functional. But the fix is easy.
Posted 13 June 2006 - 02:08 PM
Posted 21 August 2006 - 11:09 AM
I would really like to get one of these - this completely replaces the slide check?
This post has been edited by Fets25: 21 August 2006 - 11:11 AM
Posted 26 August 2006 - 03:11 PM
Found the page with that item:
Posted 05 September 2006 - 10:01 PM
Posted 06 September 2006 - 05:15 AM
Well considering I have seen a dozen slide check leaks from people using HPA I don't quite think your theory is accurate.