Special Ops Paintball: Balls Fall Out of the Ariakon Overlord - Special Ops Paintball

Jump to content


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Balls Fall Out of the Ariakon Overlord Need Help Rate Topic: -----

#1 User is offline   Black Ace 

  • Forum Newbie
  • Pip
  • Group: Members
  • Posts: 7
  • Joined: 17-August 06

Posted 22 March 2008 - 09:12 AM

Ok, I bought an Ariakon Overlord over the net, and It worked for a little bit, then the balls started falling out of the barrel. There is nothing holding them in the barrel. I can see a indentation for a ball bearing to possible go into to hold the ball, but I'm not sure. I unfortunately lost the manual, like I do with a bunch of stuff, so I have no idea what is supposed to stop the ball.

If anyone knows how the balls are supposed to be stopped and a website that may supply the replacement parts it would be greatly appreciated.
0

#2 User is offline   JayRecball 

  • Ref/Player
  • PipPip
  • Group: Members
  • Posts: 193
  • Joined: 29-October 07
  • Gender:Male
  • Location:Toronto

Posted 23 March 2008 - 10:08 AM

Ariakon Overlord Manual

here ya go... :D
0

#3 User is offline   -SMITTY- 

  • one of the original 27,731 members
  • PipPipPipPipPip
  • Group: Members
  • Posts: 1,123
  • Joined: 20-January 07
  • Gender:Male
  • Location:You know Westfield MA? Nowhere near there. ;)
  • Brigade Name:-SMITTY-

Posted 23 March 2008 - 11:28 AM

Yeah, you're missing the detent. Call Ariakon, they might be able to help you out
0

#4 User is offline   Black Ace 

  • Forum Newbie
  • Pip
  • Group: Members
  • Posts: 7
  • Joined: 17-August 06

Posted 25 March 2008 - 05:12 PM

A local paintball shop replaced the detent and it operates fine (Other than a hiss of co2 that lasted awhile... I think I didn't screw it tight enough at first, and I'm going to see how it works out. Probably fine.)

Thank you for your help.
0

#5 User is offline   JayRecball 

  • Ref/Player
  • PipPip
  • Group: Members
  • Posts: 193
  • Joined: 29-October 07
  • Gender:Male
  • Location:Toronto

Posted 26 March 2008 - 07:51 AM

try dabbing a baby bit of 3 in 1 oil on the end of the 12 gram co2 cartridge, so that it hits the puncture pin when you air up next time. That should cure the problem.
0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users