Special Ops Paintball: Installing an ION Longbow kit - Special Ops Paintball

Jump to content


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Installing an ION Longbow kit Need a little advice Rate Topic: -----

#1 User is offline   Lord Odin 

  • Forum Newbie
  • Pip
  • Group: Members
  • Posts: 40
  • Joined: 12-March 08
  • Gender:Male
  • Location:Chicago, IL
  • Brigade Name:Lord Odin

Posted 05 August 2008 - 05:48 PM

I Just installed most of the kit for the ION Longbow but ran into a couple of snags.

1. The horizontal feed adapter doesn't line up perfectly with the sight riser rail on their tops. So the picatinny rail won't lay perfectly flat. Why is this? The Spacer ring actually has a gap between it and the feed adapter, so that's not prying it up.

2. The 1/16" screws that came with the kit are way too short to mount the picatinny rail. It won't even pass halfway through the riser rail. Did they send the wrong screws?

3. The mags wiggle a little when inserted. I tried putting some electrical tape on it but that was too thick. Masking tape fit but it still doesn't take the wiggle out. Any suggestions on how to stiffen it up any?
0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users