mtaylor, on Mar 8 2008, 03:58 PM, said:
Hopefully you've thought of this, but don't do anything that will make it so you can't get the receiver halves apart. That would not be good. This has probably crossed your mind, just saving you some grief if it hasn't
Yeah it has crossed my mind for sure. I'm not sure how I'm going to do it yet. I read that some people put vasoline or something oily on one half of the receiver so it doesn't stick. I'm also pretty sure I read a while back that some people put like a sheet of paper down the middle.. or something of that sort. May I could saran wrap one side of it.. then the other. If the table saw at work had a thinner blade I wouldn't worry about it because I'd just go in and cut it in half again laster, but that saw would take out about .100 of an inch which may make it hug the internals too much, and hinder the operation of the gun.
RAYC22B, on Mar 8 2008, 04:17 PM, said:
WOW! Looks good keep us updated i too just sanded down my 98c custom.I milled off the rear site and the Tippmann logo also.I've been thinking about taking off the front handle too.I'll wait to see how yours work out.Good luck.
Thanks. I hope I can I have time to put the JBWeld in before the end of next week because I'm going to be on vacation after that so it'll be a while before I can mess with it.
I'm thinking about sanding off the Tippmann logo on mine as well.
This post has been edited by fenrisx: 08 March 2008 - 02:50 PM