Posted 27 April 2008 - 05:06 PM
Because the standard setting on the UL board is actually for the DM7. I only ask because you mentioned the frame and I had heard about this happening to others...
Posted 01 May 2008 - 06:43 AM
when i try to twist the scrw undet the hyper2 it just strat to click in the solenoid again.
That would be because you are starving your gun. If you toy with the Hyper2 without a chrono you're probably cutting off the full 150 operating pressure needed to cycle the bolt, etc...
For the back cap look at your retention screws that connect your back cap to the bolt casing, It's a long shot but maybe the boost forward vents in the back cap aren't lined up with the air release in the bolt causing too much air to vent out the back?
Posted 01 May 2008 - 10:41 AM
a fire video of the gun.