Phantom/HPA questions.. I might spend some money
Posted 19 September 2011 - 12:16 AM
Also, lets say I wanted to run a remote line from a normal HPA size...does the output matter? I noticed that all the 13/3k tanks Ive seen are 800psi output, but my current 47/3k is only set for 400...would this make any difference to a Phantom - or am I just over-thinking this?
Posted 19 September 2011 - 06:24 AM
You can run remote fine for a large tank, would be a waste on a small tank as so much gas would be wasted in the remote coil. But if it only out puts 400 PSI it won't power a phantom. Too low.
Sent from my Xoom using Tapatalk
This post has been edited by Legato: 19 September 2011 - 06:24 AM
Posted 19 September 2011 - 12:23 PM
screw in HPA tank
Re chrono (usually you have to adjust upwards as going from C02 to HPA you lose about 40FPS)
you dont need a regulator. my phantom on HPA gets a good +/- of about 5 ish.
This post has been edited by Eskimo: 19 September 2011 - 12:23 PM
Posted 20 September 2011 - 07:49 PM
Other than the spring there was no other changes made to run HPA.
CCI sells the spring. It is also included in the spare parts kit which I recomend every Phantom owner have on hand.
Send Private Message for details and questions.