Special Ops Paintball: .691 paint? from academy. - Special Ops Paintball

Jump to content


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

.691 paint? from academy.

#1 User is offline   scooby doo 

  • Forum Member
  • PipPip
  • Group: Members
  • Posts: 118
  • Joined: 12-April 08
  • Gender:Male
  • Location:dalhart TX
  • Brigade Name:machine gun expert

Posted 20 May 2010 - 06:56 PM

so I recently bought a c-series barrel that has a .691 bore size. so can anyone reccomend a good quality paint that is close to that size? preferably that can be purchased from acdemy. I think that I can get any of these: http://www.academy.com/index.php?entqr=0&a...d=1&start=0

also I will be fireing these out of my tippmann 98 so I don't want the shell to be too brittle and break in my gun.
Thanks in advance!
0

#2 User is offline   DVLCHLD 

  • Grenade/Tripmine/Landmine specialist
  • PipPipPipPipPipPip
  • Group: Members
  • Posts: 4,686
  • Joined: 08-August 05
  • Gender:Male
  • Location:Farmersville, TX
  • Brigade Name:DVLCHLD

Posted 20 May 2010 - 08:22 PM

Try the Stinger or the Spyder Black label. Both decent paint for the money and will work fine in your 98C. ALWAYS OPEN THE BOX AND INSPECT THE PAINT BEFORE YOU BUY IT.
0

#3 User is offline   scooby doo 

  • Forum Member
  • PipPip
  • Group: Members
  • Posts: 118
  • Joined: 12-April 08
  • Gender:Male
  • Location:dalhart TX
  • Brigade Name:machine gun expert

Posted 21 May 2010 - 07:26 AM

Thanks, I have used stinger before but I always wondered if the black label stuff was any good.

any one else have any suggestions?

This post has been edited by scooby doo: 21 May 2010 - 07:26 AM

0

#4 User is offline   TeleFragger 

  • Forum Member
  • PipPip
  • Group: Members
  • Posts: 184
  • Joined: 01-September 09

Posted 21 May 2010 - 07:45 AM

View Postscooby doo, on May 21 2010, 10:26 AM, said:

Thanks, I have used stinger before but I always wondered if the black label stuff was any good.

any one else have any suggestions?


my suggestion is first to check all the places you are going to play and make a list of "Not Allowed Paint"

not sure why but my local place does not allow Monster paint at all... not sure why...
__________________________________
98C==>Rap4 Stock (6 position)==> RT==> End Game Compression Barrel==> Cyclone Feed==>Tac Cap and x7 Low Prifile Hopper==> 45/88/88-4500 tanks ==> dye i3 mask==> remote line
Side Arm==>Tiberius Tac 8.1 with 4 first strike mags and 6 regular mags
Specops Custom Vest - pistol holster w. extra clip/tons of pod holders/extra mags holder (pics when it gets here!!!!)
*********Feedback**** click on a link below
-------Specops-------------MCB
0

#5 User is offline   scooby doo 

  • Forum Member
  • PipPip
  • Group: Members
  • Posts: 118
  • Joined: 12-April 08
  • Gender:Male
  • Location:dalhart TX
  • Brigade Name:machine gun expert

Posted 21 May 2010 - 08:09 AM

View PostTeleFragger, on May 21 2010, 09:45 AM, said:

View Postscooby doo, on May 21 2010, 10:26 AM, said:

Thanks, I have used stinger before but I always wondered if the black label stuff was any good.

any one else have any suggestions?


my suggestion is first to check all the places you are going to play and make a list of "Not Allowed Paint"

not sure why but my local place does not allow Monster paint at all... not sure why...



I sorta run the place where I play so almost all paint (except monsterballs) are allowed. we even have one dude that has a airsoft gun loaded with 6mm paintballs.

monster balls aren't allowed because... they are a certifiable less than lethal projectiles. there is a thread about them here somewhere. go check it out. there is also a tech pb video about them(with lots of swearing).
0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users