Special Ops Paintball: WTB stock trigger guard for TM7 - Special Ops Paintball

Jump to content


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

WTB stock trigger guard for TM7 Rate Topic: -----

#1 User is offline   xrugger 

  • I fart in your general direction!
  • Pip
  • Group: Members
  • Posts: 46
  • Joined: 27-November 07
  • Gender:Male
  • Location:Aylett, Virginia
  • Brigade Name:xrugger

Posted 02 October 2011 - 09:18 PM

I bought a used TM7 and it has the double trigger installed and I want to put a single trigger on it. I need a stock trigger guard. Anyone out there with one sitting in their gear bag?
IF YOU CAN READ THIS.....THANK A TEACHER!
0

#2 User is offline   barkingspider 

  • Forum Newbie
  • Pip
  • Group: Members
  • Posts: 30
  • Joined: 31-May 10

Posted 03 October 2011 - 07:20 PM

If you don't mind me sharing my two cents.......buy the flasc trigger and it will come with a trigger guard. At least the double trigger did, so you might want to check into the single triggers they just did a run with. The trigger provide a much better feel to the trigger pull, with less of a "spongy" feel to it.
0

#3 User is offline   xrugger 

  • I fart in your general direction!
  • Pip
  • Group: Members
  • Posts: 46
  • Joined: 27-November 07
  • Gender:Male
  • Location:Aylett, Virginia
  • Brigade Name:xrugger

Posted 04 October 2011 - 07:17 PM

I am planning on putting the flasc trigger on it that is why I only need the trigger guard. I want the single model and it doesn't come with the trigger guard.
IF YOU CAN READ THIS.....THANK A TEACHER!
0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users