help.... I have such bad luck
Posted 05 February 2011 - 03:42 PM
What type of pump is it?
You probably need to lube/oil the valve.
This post has been edited by mike7822: 05 February 2011 - 03:42 PM
Posted 05 February 2011 - 06:13 PM
The HPA's output pressure is lower than C02, and then it cannot create a seal in the valve. So, to fix this you need to lubricate the valve (lower tube of the autococker) and/or change O-rings out. To do this you need to take the frame off, take the pump, pump arm, backblock, bolt and frame off. You also need a valve tool, if you do not have one.
Posted 07 February 2011 - 11:47 AM
Send Private Message for details and questions.
Posted 07 February 2011 - 02:04 PM
In the bottom right corner of the diagram is the valve. There should be 2-3 O-rings on the valve, put lube on them. Also, check to see if the bolt is in right, the hole is the bolt should point down. Also, lube the bolt's O-rings. IF you are putting in back together, then krazy was right.
They got rid of the WGP website and the wonderful cocker diagram they had on it
Posted 07 February 2011 - 05:53 PM