Special Ops Paintball: A5A2 Commando Stock Air Thru - Special Ops Paintball

Jump to content


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

A5A2 Commando Stock Air Thru

#1 User is offline   Dj1ofDET 

  • Forum Newbie
  • Pip
  • Group: Members
  • Posts: 2
  • Joined: 25-July 09

Posted 10 June 2010 - 09:56 PM

I'm almost sure of how I'm going to pull off an air thru setup with my Palmer's stabilizer, but I wanted to do a little more research. Has anyone seen a commando stock air thru setup with a Palmer's stabilizer inside? I seem to think that there is barely enough room to fit the stabilizer inside, because of the cutout for mask clearance. If anyone has actually seen it done, speak up! :)
0

#2 User is offline   5N1P3R 

  • Master Member
  • PipPipPipPipPipPip
  • Group: Members
  • Posts: 2,832
  • Joined: 24-August 08
  • Gender:Male
  • Location:Minnesota

Posted 11 June 2010 - 07:27 PM

I have never seen it in the stock, but I have seen it in the MP5 mag connecting to the commando stock.
0

#3 User is offline   Dark Shadow Hunter 

  • Screwball, one each.
  • PipPipPipPipPipPip
  • Group: Members
  • Posts: 2,502
  • Joined: 10-December 06
  • Gender:Male
  • Location:Michigan
  • Brigade Name:Dark Shadow Hunter

Posted 13 June 2010 - 05:55 AM

Take the back plate off the stock to see how much room you have in there. I am not 100% sure, but I think it can be done. I would recommend using a direct stabilizer for the project.

GH Militia Man, who hasn't posted here in forever, has a thread on how to install a Palmer's Direct Stabilizer into a SAW Stock. The principles should be about the same for the commando stock.

:D Linky

Also I recommend you drill an access hole so you can adjust the reg without having to take off the back plate.

This post has been edited by Dark Shadow Hunter: 13 June 2010 - 05:56 AM

0

#4 User is offline   Dj1ofDET 

  • Forum Newbie
  • Pip
  • Group: Members
  • Posts: 2
  • Joined: 25-July 09

Posted 14 June 2010 - 07:00 PM

Thanks guys. Do you have a link to the MP5 mag installation?
0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users